Formax FD 6100, Руководство по обслуживанию

Страница: 46 / 113

ISSUE : 21/09/03
FD 6100 MAINTENANCE
MANUAL
REVISION : 2.1
SECTION : 01 PAGE 45
CONTENTS
4.3.2 FEEDER AB CLUTCHES SETTING
PURPOSE: To ensure the correct document pre-loading position and to ensure as well the proper
synchronisation between feeders A and B:
- A too low stopping position (clutch delay too long) causes deformation of
thin and medium-thickness documents by the stop and consequently misalignment
from both bins.
- A Too high stopping position (clutch delay too short) includes risks of
gripping defaults of thick documents by the base and of misalignment with a second
document.
ADJUSTMENT PROCEDURE:
- To control the stop position for the feeder A-B, it is necessary to select a job which uses the
envelope feeder as well as feeder A (or B).
- Load feeder A with only one document, but without any envelope in the feeder E.
- Start the job (push the START key).
- Rotate the feeder A-B, without disconnect it, in order to look at the document stop position.
- If the position isn’t correct (see the picture below), it is necessary to apply the “A & B
CLUTCHES SETTING” procedure to adjust the timing value.
- Perform again this adjustment until the stop position is correct, then apply the same procedure
for the feeder B
ALLOWED STOP POSITION
ALLOWED VARIATION