![background image](http://html1.mh-extra.com/html/formax/fd-2052il-autoseal-system/fd-2052il-autoseal-system_operators-manual_2319982009.webp)
5
The alignment base stoppers are used to keep
the printer from making contact with the sealer
infeed. The exit rollers of the printer and the sealer
infeed throat should not come into contact during
operation. There should be a gap of approximately
1/8” between the rollers and the sealer Infeed
throat.
Fig. 9
Locking pins
Alignment base stopper
2. Pull the stopper out from the pressure seal
alignment base until it meets the edge of the
printer alignment base, be sure to maintain the gap
between the printer outfeed and the sealer infeed.
(Fig. 10a & 10b)
Fig. 10a
Fig. 10b
Alignment Stoppers
1. Slide the printer up to the sealer infeed throat so
that there is approximately a 1/8" gap between the
printer out feed and the sealer infeed throat. Using
a 1/8” standard allen wrench, loosen the locking pin
of each alignment base stopper. (Fig. 9)
Fig. 11
3. Using the allen wrench, tighten both locking pins
to hold the stopper into place. Now it’s possible to
slide the printer away from the 2052IL infeed throat
and back into place without having to reset the
position. (Fig. 11)
Repeat with the second stopper.
Содержание FD 2052IL AutoSeal System
Страница 1: ...FD 2052IL AutoSeal System OPERATOR MANUAL FIRST EDITION 12 2007...
Страница 2: ......
Страница 4: ......