The Blade Assembly
Adjusting the blade pressure (no paper required)
1. (i) Switch the power ‘on’ by turning the Emergency stop button clockwise to release the
safety latch.
(ii) Select the Tools tab at the bottom of the touch screen, the display will
change to that shown below.
(iii) Select the up arrow to move the blade to the Top Dead Centre position.
.
4. Unlock the cam adjustment lever by turning
counter-
clockwise & then rotate the cam
adjustment handle in the direction shown in the diagram below to adjust the blade
pressure.
Click on Up Arrow to
put Anvil into Top
Dead Cent
er
position
(TDC)
Page 34
CREASING
Replacing Creasing Blade Set
Installing blade sets.
1.
Before removing the blade assembly, ensure that the lower blade / anvil is NOT
at ‘top dead center’, Switch the machine off.
2.
Remove the stacker unit and lift the exit guard (Fig. 9.)
3.
Push down On the lay side of the bridge assembly (1) & the pull back towards the
operators side (2) (Fig. 10)
1
2
Bridge Assembly
FIG. 9
FIG. 10
Page 35
SYSTEM