P| 7
CUSTOM THE BREEZY SMALL PAVILION
www.ForeverRedwood.com
NOTE:
In order to know where the post needs to be placed, check the numbers on them. If the post is not marked, then place the
single Supports on the ground to locate the markings for each post position and clearly set your bearings. (“Don´t attach yet, only
place them on the ground to begin with”).
Note:
Before install the anchor bases make sure that the ground is level using a carpenter's level or hydro-level (water level).
Step 1:
Install the anchor bases
(10)
. After that, set your post
(1)
in the saddle of the anchor bases
(10)
. Drill a ø ¼´´ hole in the
post prior to anchoring to facilitate the ratcheting of the hardware. After that, use a 3/8´´ X 3´´ lag bolts
(A)
to attach each post to
its respective anchor bases
(10)
.
Step 2:
Attach the single supports
(2)
to the posts with 3/8´´´x 7 1/2´´ bolts
(B)
. Check the marked on each support and place as
drawings shown.
Note:
Don’t completely tighten yet the bolts – you will need the install the supports with in between blocking first.
SP-1
SP-2
P-4
P-1
P-2
P-3
10
3/8´´ X 3´´ Lag Bolts
3/8´´ X 7 1/2´´ Bolts
