9
EN
DE
FR
NL
LED 1 to 4
CONFIGURATION MASTER – SLAVE FUNCTION
The Forest Shuttle M Receiver can be configured as MASTER or SLAVE, requiring two
motors. MASTER: the controlling motor. SLAVE: the MASTER following motor.
MASTER – SLAVE FUNCTION 1 (NORMAL SHUTTLE
®
M RECEIVER 5232000003):
1
2
3
4
5
6
PAGE
6
In this master - slave function, two Shuttle M motors are used on one track.
Direction of rotation of both motors is the same.
INSTALLATION STEPS:
Make sure your system is fully assembled and mounted on the ceiling or wall before you
start installing the two motors.
Connect port 1 (motor A) to port 1 (motor B) with a UTP, FTP cable or an 8 wire flat cable.
Program the MASTER motor: push the configuration button 17 times shortly,
LEDS 1 to 4 light up one more time with each push. After 17 presses, once
more push the button and hold for 4 seconds. LEDs 1 to 4 will move with
every press. (see configuration
overview on page 6)
Program the SLAVE motor: press the configuration button 18 times shortly, LEDS 1 to 4
will move with every press.
After 18 presses, press the button once more and hold for 4 seconds. LED 2 will blink 3
times and go out.
Now the SLAVE motor will follow the movement of the MASTER motor. Only the MASTER
motor can be controlled.
End limits can be set now and remotes can be programmed.
