Forest Garden Ltd, Unit 288 Hartlebury Trading Estate, Hartlebury, Worcestershire, DY10 4JB
9
L
Maintenance.
We recommend that you treat your shed at the beginning of each season with a
wood preservative treatment. Apply in
accordance with the manufacturers instructions.
Regularly check all fixings are secure.
Biocidal Product Regulation (EU 528/2012) Article 58 Information
This article contains timber treated with Celcure AC-500, incorporating biocidal products to give protection against wood destroying insects & wood rotting fungi
.
Contains:
Basic copper carbonate (Copper (II) carbonate – Copper (II) hydroxide (1:1)), Boric acid, Benzalkonium chloride.
Wear gloves when handling freshly treated wood. Avoid breathing dust when cutting treated or untreated wood. Dispose of off-cuts responsibly – do not burn.
7
E
K
J
Attention
Take care when
cutting and trimming
the roof felt.
Unroll the felt and place a section on to each eaves so that there is a 50mm overhang on the
three edges as shown. Fix this to the roof using felt nails spaced in 150mm intervals. Cut and
fold the corners securing with a single felt nail for each.
Place the two remaining sections as shown making sure that the last piece overlaps the others.
Again secure each sheet in place using felt nails spaced in 150mm intervals.
10
11
8
5
N
Secure a Z’ bracket to each end of the 1462mm battens using a single
25mm screw for each bracket. Position the battens as shown so that there
is four battens on either side of the truss and the Z’ bracket sits on the
framework. Secure the battens in position using a 25mm screw for each Z’
bracket. You will need to stagger the battens to allow the bracket to sit
properly on the truss.
R
Before fixing the Hasp to the door, make sure that it is in line with the framing
on the reverse of the door and that it closes over the Staple. Fix this in place
using 3 x 25mm screws.
Position the Staple opposite, again making sure that it is in line with the
framing behind and fix it in place using 2 x 25mm screws.
6
Place the barge boards against the ends of the workshop so that they are flush
with the overhang of the roof and in line with the top. Fix each in place using
4x40mm screws.
Place the finial over the top where the barge boards meet and fix it in place
using 2 x 30mm screws.
Repeat for the opposite end of the shed.
Lift the roof sections into place making sure that they are in line with
the apex and the front and back panels of the shed.
Fix the roof in place using 30mm nails spaced in approximately
300mm intervals (Make sure the nails locate into the framework of
the truss and panels)
Place a roof sheet on top of one of the 1540mm
battens. Make sure the board is sat on the narrow
side of the batten and that it is flush on all sides. Fix
this in place using 30mm nails spaced in 300mm
intervals.
Place the 1710mm strips so that they cover the joins at
each corner and between the panels. Fix each corner
strip in place using 3x30mm screws and each middle
strip with 3 x 40mm screws
