USER MANUAL
200W LED MOVING HEAD SPOT BEAM WASH LIGHT
1
2
3
PIN 3
PIN 2
120
Ω
Unit: mm
Ⅵ
INSTALLATION AND CONNECTION
1. Installation
Be sure to install this product should be at least 0.5 m from the flammable materials
Screw one clamp each via a M12 screw and nut onto the Omega holders.
Insert the quick-lock fasteners of the first Omega holder into the respective holes on the
bottom of the device. Tighten the quick-lock fasteners fully clockwise. Install the second
Omega holder.
Pull the safety-rope through the holes on the bottom of the base and over the trussing
system or a safe fixation spot. Insert the end in the cabinet and tighten the safety screw.
Please refer to the picture below:
2. DMX connection
Connect the provided XLR cable to the female 3-pin XLR output of your controller and the
other side to the male 3-pin XLR input of the moving head. You can chain multiple Moving
head together through serial linking. The cable needed should be two core, screened cable
with XLR input and output connectors. Please refer to the diagram below.
DMX-512
C
ONNECTION WITH
DMX
T
ERMINATOR
For installations where the DMX cable has to run a long distance or is in an electrically noisy
environment, such as in a discotheque, it is recommended to use a DMX terminator. This
helps in preventing corruption of the digital control signal by electrical noise. The DMX
terminator is simply an XLR plug with a 120 Ω resistor connected between pins 2 and
3,which is then plugged into the output XLR socket of the last fixture in the chain. Please
see illustrations below:
07
06
07
