6
Be sure to follow the grounding
instructions on page 3 of this
manual while attaching the
speed control to a power outlet.
Please note that the power cord
on a foot or dial speed control,
and NOT the motor power cord,
plugs into an electrical outlet.
Motors should not be plugged
directly into an outlet.
Connecting the Foot Speed Control
The electrical specifications for your power tool
are listed on the label on back of motor.
It shows proper voltage and currents to use with
your power tool.
A 115 Volt, 50/60 cycle (Hz) motor can be used
with the models C.FCT-1 and C.SCT-1 foot
controls on 115 Volt AC current only. The 230
Volt, 50/60 cycle (Hz) motor can be used with the
models C.FCH-2 and C.SCH-2 foot controls on
230 Volt AC current only.
To connect the foot control to the motor, insert
the 3-prong plug on the end of the motor power
cord into the socket connector on the shorter
power cord on the foot control. With the motor
fwd/off/rev switch in the “off” position, plug the
3-prong plug on the longer power cord from the
foot control into a proper 3-prong power outlet.
When your foot is NOT pressing the foot
control, the motor should not be running.
Your foot must maintain steady contact with the
pedal during operation. Holding the handpiece in
your hand, put the motor fwd/off/rev switch in the
desired “on” position, begin with a light touch,
start out slowly and gradually increase the speed.
Finding the right speed for any specific
task is a matter of experimentation
and experience.
Hold the handpiece securely
before selecting the rotation
direction and turning the motor to
the desired “on” position.
Hanging Motor Installation
M.SR Motors should be hung up
about 30
″
– 40
″
above the work
surface and to the right of the work if
you are right handed or to the left of
the work if you are left handed.
Use a safety clip or hook like the one
shown to prevent the motor from
jumping or twisting off an open hook
at start up or during use. Properly securing the
motor will help to prevent injury to the user.
All Foredom motor hangers come with a safety
clip (see page 15). If an “open hook” is used be
sure to secure the motor to it with wire or
heavy tape.
Connecting
the Table Top
Dial Speed
Control
The motors can
also be used with the
C.EM-1 (115 Volt)
or
C.EMH-2 (230 Volt)
dial speed control
on AC current.
1. Plug the 3-prong power cord from the
motor into the the short cord on the dial control.
2. With motor fwd/off/rev switch in the “off”
position and the dial control indicator also in
the “off” position, connect the detachable power
cord to the dial control outlet on the back and
into a proper 3-wire outlet (see page 3).
3. Holding the handpiece in your hand, put the
motor fwd/off/rev switch in the desired “on”
position, begin with a light touch, start out
slowly and gradually increase the speed.
4. Overloading the motor may blow the fuse.
The fuse can be found below the detachable
power cord receptacle.
Forward/ Off/Reverse
Rocker Switch on motor
Fuse compartment
and spare fuse are
located below
detachable power
cord receptacle
3-prong plug connects
to power outlet
3-prong
plug connects
to power outlet
outlet for
motor plug
socket
connector for
motor plug
