1.10 Package and Ergonomics
1.10.1 General Component Package
Guidelines
WARNING: Do not modify, drill, cut or
weld any suspension components,
specifically the steering gear system,
subframe or anti-roll bars, springs or
shock absorbers including mounting
brackets.
The Vehicle Converter must ensure that sufficient
clearance is maintained under all drive conditions
to moving components such as axles, fans,
steering, brake system etc.
The Vehicle Converter is responsible for all
installed components during the conversion. The
durability must be confirmed by appropriate test
procedures.
1.10.2 Driver Reach Zones
Controls and/or equipment required to be used
while driving should be located within easy reach
of the driver so as not to impair driver control.
1.10.3 Driver Field of View
WARNING: Make sure that the modified
vehicle complies with all relevant legal
requirements.
1.10.4 Conversion Effects on Parking
Aids
WARNING: Ensure that monitors
mounted in the cabin meet the interior
package and safety requirements.
On conversions requiring a rear camera, the
reverse signal may be taken as described in the
reversing lamps section.
Refer to: 4.3 Exterior Lighting (page 63).
1.10.5 Aids for Vehicle Entry and Exit
Steps
WARNINGS:
Make sure that the modified vehicle
complies with all relevant legal
requirements.
If this modification alters the
homologated dimensions, a new
approval may be necessary.
CAUTION: Make sure that
reinforcements are installed to maintain
the integrity of the original body
structure.
Steps can be ordered as an accessory on the base
vehicle. Please check for availability.
Where additional steps are installed the required
ground clearance line must be maintained.
The Vehicle Converter must make sure that a
movable step is set in the stored position when
the vehicle is running. The step surface must be
non-slip.
Rear View Mirrors
NOTE:
Overall width with exterior rear view
mirrors extended is 2163 mm.
Description
Item
Maximum Body Width: 1860mm
X
Date of Publication: 02/2017
FORD
RANGER
2015
