EN
Copyright © 2015
P a g e
|
9
www.Ford-tools.com
9
OVERLOAD
10
CLEANING AND MAINTENANCE
Attention !
-
Before performing any work on the equipment, pull
the power plug.
10.1
Cleaning
x
Keep the ventilation slots of the machine clean to prevent overheating of
the engine.
x
Regularly clean the machine housing with a soft cloth, preferably after
each use.
x
Keep the ventilation slots free from dust and dirt.
x
If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc.
These solvents may damage the plastic parts.
10.2
Lubrication
The machine does not require any specific lubrication.
11
TECHNICAL DATA
Model
FX1-1070
Voltage / frequency
230V-50Hz
Power input
850W
No load speed
11000 min-1
Max. disc diameter:
Ø 100 mm
Drive spindle thread:
M 10
Overloading will cause damage to the motor of your angle grinder. This can happen
if your angle grinder is subjected to heavy use for prolonged periods of time.
Do not in any circumstances, attempt to exert too much presure on your angle
grinder to speed up your work. The abrasive discs operate more efficiently when light
pressure is exerted, thus avoiding a drop in the speed of your angle grinder. If your
angle grinder becomes too hot, run your angle grinder under no load for 2-3 minutes
until it has cooled to normal operation temperature.
FX1-1070
