Ford FX1-1048, Инструкция по эксплуатации, Страница: 8 / 9

FX1-1049
EN
Copyright © 2015
P a g e | 7
www.Ford-tools.com
8.3 Use (Fig. 4
ƒ
After placing the tip of the tool on concrete surface, switch the tool ON.
ƒ
By utilizing the weight of the machine and by firmly holding the demolition
hammer with both hands, you can control the subsequent recoil motion.
After long time of use, the cylinder case becomes hot.
Therefore, be careful not to burn your hands.
Don’t apply big pressure on the machine. The hammer
mechanism is activated by applying a slight pressure on the
tool when the chisel bit is in contact with the work-piece.
9 CLEANING AND MAINTENANCE
Attention !Before performing any work on the equipment, pull
the power plug.
9.1 Cleaning
ƒ
Keep the ventilation slots of the machine clean to prevent overheating of the
engine.
ƒ
Regularly clean the machine housing with a soft cloth, preferably after each
use.
ƒ
Keep the ventilation slots free from dust and dirt.
ƒ
If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc.
These solvents may damage the plastic parts.
10 TECHNICAL DATA
MODEL N° FX1-1049
Rated Voltage 220-240 V
Rated Frequency 50 Hz
Rated Power 1050 W
Rotation speed 750 min
-1
Protection class II
Impact rate 4300 min
-1
Cable length 3 m + VDE plug
11 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level L
pA
98 dB(A)
Acoustic power level L
wA
105 dB(A)
ATTENTION! Wear hearing protection when sound pressure is
over 85 dB(A).