FX1-1049
EN
Copyright © 2015
P a g e
|
6
www.Ford-tools.com
When carrying out work, always hold the device with both hands and ensure
that you have a stable standing position.
7
BEFORE USING THE TOOL FOR THE FIRST TIME
Examine the place where the device is to be used for hidden electrical cables,
gas and water pipes using a pipe finding device.
Before connecting to !he mains, ensure care that the mains voltage
corresponds to the details on the rating plate.
Ensure that the power switch is in the OFF position. If the plug is connected to
a mains while the power switch is in the ON position, the power tool will start
operating immediately, which could cause serious accidents.
When the work area is removed from the power source, use an extension cord
of sufficient thickness and rated capacity. The extension cord should be kept
as short as practicable.
7.1
Fitting and changing tools (Fig. 2)
The device is equipped with a SDS-Max attachment system.
Clean tools and grease with a thin layer of machine grease before fitting.
Pull back fastening sleeve and hold.
Push and rotate the dust-free tool into the tool holder as far as it will go. The
tool will lock automatically.
Check that it has locked by pulling the tool
7.2
Removing SDS-Max tool
Pull back fastening sleeve, hold and remove tool.
Accessories can be
hot after use. Don’t touch the tip of
accessory by hand! Please always use protective floves to
remove accessory.
8
OPERATION
8.1
Switching ON/OFF
Switching on: Press the operating switch (8).
Switching off: Release the operating switch(8)
For continuous operation just press the lock-on button (6) on the left side of the
handle. the lock-on button can be release by pressing the switch trigger again.
8.2
Handle attachment (Fig. 3)
For reasons of safety, only use the hammer drill with handle attachment.
You will be able to obtain a safe body position when working by rotating the
handle attachment.
Install the fastening screw, camping block and frame successively onto the
handle.
Place the collar onto the collar mount and then let the two holes of collar at
the both ends of the clamping block.
Adjust the handle subassembly to a desire position, finally securely tighten the
handle.
remove the auxiliary handle subassembly in the opposite way.