The doors will lock then unlock to confirm
that programming was successful.
To program additional personal entry
codes, repeat Steps 1-3, then for Step 4:
•
press
3·4
to save personal code 2
•
press
5·6
to save personal code 3
•
press
7·8
to save personal code 4
•
press
9·0
to save personal code 5.
You may also program a personal entry
code through the MyFord Touch system
(if equipped).
Tips:
•
Do not set a code that uses five of the
same number.
•
Do not use five numbers in sequential
order.
•
The factory-set code will work even if
you have set your own personal code.
Recalling Memory Positions (If
Equipped)
The programmed entry codes will recall
driver memory positions as follows:
•
Entry code 1 will recall driver 1 memory
positions.
•
Entry code 2 will recall driver 2 memory
positions.
•
Entry code 3 will recall driver 3 memory
positions.
Note:
Personal entry codes 4 and 5 will not
recall memory positions.
Erasing a Personal Code
1.
Enter the factory-set 5-digit code.
2. Press and release
1·2
on the keypad
within five seconds.
3. Press and hold
1·2
for two seconds.
You must do this within five seconds
of completing Step 2.
All personal codes are now erased and only
the factory-set 5–digit code will work.
Anti-Scan Feature
The keypad will go into an anti-scan mode
if you enter the wrong code seven times
(35 consecutive button presses). This
mode disables the keypad for one minute
and the keypad lamp will flash.
The anti-scan feature will turn off after:
•
one minute of keypad inactivity
•
pressing the unlock button on the
remote control
•
switching the ignition on
•
unlocking your vehicle using intelligent
access.
Unlocking and Locking the Doors
To Unlock the Driver Door
Enter the factory-set 5-digit code or your
personal code. You must press each
number within five seconds of each other.
The interior lamps will illuminate.
Note:
All doors will unlock if you enable the
all-door unlocking mode. See
Locking and
Unlocking
(page 59).
To Unlock All Doors
Enter the factory-set code or your personal
code, then press
3·4
within five seconds.
To Lock All Doors
Press and hold
7·8
and
9·0
at the same
time (with the driver door closed). You do
not need to enter the keypad code first.
To Release the Trunk
Enter the factory-set code or your personal
code, then press
5·6
within five seconds.
Displaying the Factory Set Code
With Integrated Keyhead Transmitters
Note:
You will need to have two
programmed passive anti-theft keys for this
procedure.
64
Fusion Energi / Fusion Hybrid (CC7), enUSA
Locks
Содержание FUSION ENERGI 2015
