NOW INSERT THE 4 PIN TOUCH CABLE
JUMPER FROM THE FACTORY PCB
LOCATION TO THE INTRAPHEX PCB
LOCATION. MAKE SURE THAT THE
CONTACTS OF THE CABLE FACE
UPWARD. LOCK BOTH CONNECTORS
FIRMLY.
VIEW OF 4 PIN TOUCH RIBBON TUCKED
AWAY UNDER PCB.
NEXT, PLUG IN CABLE TO PCB IF NOT
ALREADY DONE. BE SURE TO PLUG SIDE
LABELED “MONITOR SIDE” TO THE PCB.
ROUTE THE CABLE OUT THE LOWER
CORNER. THERE WILL BE NO NEED TO
MODIFY THE CASE AS THERE IS ENOUGH
ROOM FOR THE HARNESS TO PASS
THROUGH IN THE CORNER.
REPLACE THE FACTORY 4 PIN TOUCH
RIBBON CABLE TO THE OPEN
CONNECTOR ON THE INTRAPHEX PCB.
MAKE SURE THE CONTACTS FACE
UPWARD. PUSH BLACK LOCKING TABS
IN TO SECURE IT.
