Programming a Personal Entry Code
To create your own personal entry code:
1.
Enter the factory-set code.
2. Press
1·2
on the keypad within five
seconds.
3. Enter your personal 5-digit code. You
must enter each number within five
seconds of each other.
4. Press
1·2
on the keypad to save
personal code 1.
The doors will lock then unlock to confirm
that programming was successful.
To program additional personal entry
codes, repeat Steps 1-3, then for Step 4:
•
press
3·4
to save personal code 2
•
press
5·6
to save personal code 3
•
press
7·8
to save personal code 4
•
press
9·0
to save personal code 5.
You may also program a personal entry
code through the information display.
Tips:
•
Do not set a code that uses five of the
same number.
•
Do not use five numbers in sequential
order.
•
The factory-set code will work even if
you have set your own personal code.
Recalling Memory Positions (If
Equipped)
The programmed entry codes will recall
driver memory positions as follows:
•
Entry code 1 will recall driver 1 memory
positions.
•
Entry code 2 will recall driver 2 memory
positions.
Note:
Personal entry codes 3, 4 and 5 will
not recall memory positions.
Erasing a Personal Code
1.
Enter the factory-set 5-digit code.
2. Press and release
1·2
on the keypad
within five seconds.
3. Press and hold
1·2
for two seconds.
You must do this within five seconds
of completing Step 2.
All personal codes will erase and only the
factory-set 5-digit code will work.
Anti-Scan Feature
The keypad will go into an anti-scan mode
if you enter the wrong code seven times
(35 consecutive button presses). This
mode disables the keypad for one minute
and the keypad lamp will flash.
The anti-scan feature will turn off after:
•
one minute of keypad inactivity
•
pressing the unlock button on the
remote control
•
switching the ignition on.
Displaying the Factory Set Code
Note:
You will need to have two
programmed passive anti-theft keys for this
procedure.
To display the factory-set code in the
information display:
1.
Insert a key into the ignition and switch
the ignition on for a few seconds.
2. Switch the ignition off and remove the
key.
3. Insert the second key into the ignition
and switch the ignition on.
The factory-set code will display for a few
seconds.
Note:
The code may not display until after
any other warning messages first display.
58
Super Duty (TFA) Canada/United States of America, enUSA, First Printing
Locks
Содержание 2016 SUPER DUTY
Страница 3: ......
Страница 9: ...6 Super Duty TFA Canada United States of America enUSA First Printing ...
Страница 497: ...494 Super Duty TFA Canada United States of America enUSA First Printing ...