E151956
1.
Insert the key blade into the slot on the
bottom of the handle and press up.
2. Applying upward pressure, move the
cap rearward to release it. Gently
remove the key while doing so.
To install the cap:
E151957
1.
Place the cap just forward of the key
cylinder.
2. Applying pressure to the cap, move it
forward until it is in place. You may
hear a snap as it engages.
Make sure you have properly installed the
cap by trying to move it rearward.
Replacing the Battery
Note:
Refer to local regulations when
disposing of transmitter batteries.
Note:
Do not wipe off any grease on the
battery terminals or on the back surface of
the circuit board.
Note:
Replacing the battery will not delete
the transmitter from the vehicle. The
transmitter should operate normally.
A message appears in the information
display when the remote control battery
is low. See
Information Messages
(page
104).
Integrated Keyhead Transmitter
The remote control uses one coin-type
three-volt lithium battery CR2032 or
equivalent.
Press the button to release the key before
beginning the procedure.
E151798
1.
Insert a screwdriver in the position
shown and gently push the clip.
2. Press the clip down to release the
battery cover.
47
Fusion (CC7) Canada/United States of America, enUSA
Keys and Remote Controls
Содержание 2015 FUSION
Страница 3: ......
Страница 9: ...6 Fusion CC7 Canada United States of America enUSA ...
Страница 135: ...6 way power seat E176793 132 Fusion CC7 Canada United States of America enUSA Seats ...
Страница 481: ...478 Fusion CC7 Canada United States of America enUSA ...