Ford 2006 Freestar, Руководство пользователя

Страница: 62 / 320

Resetting the PSD
The power sliding door may operate incorrectly or not at all because of
the following conditions:
•
a low voltage or dead battery
•
the door is left opened for more than 6 hours
•
the battery is disconnected
•
the PSD Passenger compartment fuse panel fuse (fuse #11) is
removed or blown. Refer to
Fuses and relays
in the
Roadside
Emergencies chapter.
If any of the above conditions has occurred, perform the following steps
to reset the PSD so that electronics can relearn the open and closed
positions:
1. Check to see if PSD is securely closed.
2. Make sure the gearshift is in (P) Park.
3. Push the PSD control on the overhead console to open the door.
4. Wait five (5) seconds and close the door by pressing the PSD control
on the overhead console.
5. Wait five (5) seconds and repeat Steps 3 and 4 then go on to Step 6.
6. Repeat Steps 3–5 for opposite door.
If the door still does not operate correctly:
7. Ensure the ignition is in the OFF position
8. Remove the PSD fuse (fuse #11) from the passenger fuse panel and
leave it out for thirty (30) seconds. Refer to the chapter on Fuses and
Relays. Refer to
Fuses and relays in the Roadside emergencies
chapter.
9. Reinstall the fuse and wait ten (10) seconds.
10. Repeat Steps 1–6 above.
If the door still does not operate correctly, see your dealer for service.
Sliding Door Child Safety Lock
Your vehicle is equipped with a sliding door child safety lock that helps
prevent passengers from operating the sliding door by using the inside
door handle, refer to the
Childproof door locks
in the
Locks and
security
chapter.
2006 Freestar (win)
Owners Guide (post-2002-fmt)
USA
(fus)
Driver Controls
62