U45W Blue Jay
User Manual
25
TROUBLESHOOTING GUIDE
No. Problem
Problem Cause
Solution
1
3
5
6
7
2
4
The transmitter
indicator light
is off.
The drone is
underpowered
or won’t fly.
The drone
indicator light
is off.
Can’t see an
image.
Can’t control by
mobile device.
Drone and
transmitter fail
to pair.
The drone can’t
hover or tilts to
one side.
1. Low battery.
1. Damaged propeller.
1. Low battery.
1. The indicator light is off.
1. No calibration.
1. Replace the transmitter battery.
1. Replace the propeller.
1. Recharge the drone battery.
1. Check the wire and connect well.
1. See above.
1. Recalibrate the drone.
3. Poor contact.
3. Incorrect installation of propeller.
3. Poor contact.
3. Damaged camera.
1. User error.
3. User error.
3. Motor casing damaged.
5. The motor is damaged.
2. Batteries are inserted improperly.
2. Low battery.
2. The battery is expired or old.
2. Signal interference.
1. Camera not connected, or has poor
contact.
2. Signal interference.
2. Damaged propeller.
2. Reinsert the batteries.
2. Recharge the drone battery.
2. Buy a new battery from force1rc.
com to replace the battery.
2. Disconnect and reconnect.
2. Restart the drone and power on the
transmitter.
2. Replace the propeller.
3. Clean the battery housing/contacts.
3. Install the propeller in accordance
with the user manual.
3. Disconnect the battery and then
connect it with the plug again.
3. Buy a new camera from
force1rc.com.
1. Consult instructions.
3. Operate the drone step by step in
accordance with the user manual.
3. Replace the motor casing.
5. Replace motor.
4. Buy spare parts from force1rc.com
and replace damaged parts.
4. Place drone on level ground to
recalibrate.
4. Damaged components.
4. The gyro did not reset after violent
crash.
Questions or comments? Contact [email protected] for technical support.
