Force PT110921, Руководство оператора

Страница: 13 / 28

ENGLISH
ENGLISH
13
OPERATION
Tip: Test run
Check the grinding tool before use. The grinding wheel, disc or
accessory must be flawlessly mounted and be able to rotate freely.
Perform a test run of at least 30 seconds without load. Do not use
damaged or vibrating grinding tools.
WARNING
Wheels used for edge grinding may break or kick-back if they bend or
twist while the tool is being used to do deep grinding. To reduce the risk
of serious injury, limit the use of these wheels with a standard Type 27
guard to shallow notching (less than 1/2” in depth). The open side of the
guard must be positioned away from the operator.
!
!
Always use the correct voltage: The voltage of the power supply must match
with the values on the nameplate of the tool.
Switching On and Off
To start the tool, press the button and at the same time move the button forward.
Then the tool will run continuously. To turn the tool off, just press the button.
Grinding
The best grinding results can be achieved with a 30° to 40° approach angle.
Move the tool back and forth with moderate pressure. In this manner, the work
piece will not over-heat nor discolor and no ridges will be formed.
MAINTENANCE
Maintenance and Cleaning
l
Before performing any work on the power tool, disconnect the power cord plug
from the power source from the power source.
l
For safe and proper working, always keep the tool and ventilation slots clean.
l
Regularly check to see if any dust foreign material has entered the slots near the
motor and around the on/off switch. Use a soft brush to remove any accumulated
dust. Wear safety glasses to protect your eyes while cleaning.
l
If the body of the tool needs cleaning, wipe it with soft damp cloth. A mild
detergent can be used but nothing containing alcohol, petrol or any other strong
cleaning agent.
l
Never use caustic agent to clean plastic parts.
l
Regularly check the hardware. They may vibrate and loosen over time.