Part No 60121508 Rev E
8 Instructions, Force NRG Customer Assembly
Bumper Installation
i.
Remove packaging materials from camber tube at rear of frame
assembly
j.
Using the clamps from
[SHEET #3]
and the 4mm Allen Key from
[SHEET #1]
, Install the bumper to the handcycle
k.
Slide the bumper clamp with flag holder onto the (Rider
’
s left
hand) bumper receiver
i.
NOTE: Clamps can only go on one way with the flange
to the outside of the bumper receiver
l.
Slide the other bumper clamp onto the (Rider
’
s right hand)
bumper receiver
m.
Slide the bumper through the clamps into the bumper receivers
n.
Once the bumper has bottomed out against the camber tube,
tighten both clamps ensuring that the flag holder remains
vertical. (Recommended torque: 8-9 N.M.)
o.
6.
Wheels and Tires
a.
Attach the wheels to the rear of the frame using a 10mm Allen
Key or
1/4”
Allen Key depending on what make of wheels you
have.
b.
Determine which wheel goes on the left vs right side of
handcycle based on the arrow on the sidewall of the tires. It can
be hard to see, but keep looking
–
it’s there.
c.
Insert the axles into the axle receivers in the camber tube
ensuring that axles are going in straight to prevent cross
threading which could damage the axle receivers and/or axles
d.
Tighten the axles with the appropriately sized Allen Key
(recommended torque: 15-20 N.M.)
e.
7.
Tire Inflation
a.
Remove the valve stem cap
b.
Loosen up needle to outward position
i.
NOTE: Not required for rear wheels
c.
Thread on valve stem adapter
d.
Inflate tires using a standard Schrader air nozzle with a Presta
valve adapter or a Presta valve nozzle (do not exceed
recommendations embossed on tire). We recommend
approximately 80 psi and then fill to preference)
8.
Install Safety Mirror
a.
Remove plastic bolt from mirror from
[SHEET #4]
with a 3mm
Allen Key found on
[SHEET #1]
.
b.
Wrap the mirror strap around the top of the fork in the location
of your preference
c.
Reinstall the plastic bolt and tighten until mirror is secure
