Force 18 V NiCd PT100118, Руководство оператора, Страница: 9 / 22

7
d) Plug the battery charger into home socket (120v)
and connect to adaptor, the red light is on and
the green light is off. When insert the battery in
the power connected charger, the red light and
the green light are on at the same time. When the
battery is fully charged, the red light is still on, but
the green light is off. The approximate charging
time is less than 5 hours, when battery is fully
charged, user must disconnect the charger from
the power supply. Pull the battery pack out of the
adaptor for ready to use.
e) To insert the battery pack (10) into the tool, align
the tongue on the battery pack with the groove in
the housing and slip it into place. Always insert it all
the way until it locks in place with a little click. If not,
it may accidentally fall out of the tool, causing injury
to you or someone around you. (Pic.(A))
f) Do not use force when inserting the battery pack.
If the pack does not slide in easily, it is not being
inserted correctly
Changing Bits
Always be sure that the tool is switched off and the
battery pack is removed before carrying out any work
on the tool.
Before any action on the tool (e.g. battery charge, bit
change and maintenance etc.) and after operation, set
up the rotational direction switch to the center position
to avoid unintentional actuation of the on/off switch.
1) Hold the chuck ring (b) and turn the chuck collar (a)
counter-clockwise to open the chuck jaws. Place the
bit in the chuck as far as it will go.
2) Hold the chuck ring (b) firmly and turn the chuck
collar (a) clockwise to tighten the chuck.
3) To remove the bit, hold the chuck ring (b) and turn
the chuck collar (a) counter-clockwise.
OPERATION
Starting Operation
Switching on:
To start the tool squeeze on the On/Off switch (1) and
then keep it pressed down.
Switching off:
To stop the tool, release the On/Off switch (1).
Product features
The number of product features refers to the illustration
of the tool on the graphics page (Pic. A-B)
1. On/Off switch
2. Keyless chuck
3. Torque preselection ring
4. Torque pointer
5. Gear selector
6. Bubble
7. Rotational direction switch
8. Soft-grip
9. Battery unlocking button
10. Battery pack*
11. Power light
12. Battery capacity indicator
13. Screwdriver bit*
14. Battery charger
15. Adaptor
16. Charging indicator
*The accessories illustrated or described may not be
included as standard accessories..
ASSEMBLy
Battery Charging
To charge your tool`s battery, use the same model
charger and battery pack provided with your tool. Using
other batteries can lead to injuries and pose a fire
hazard.
Do not continue to press the On/Off switch after
the tool has been automatically switched off. The
battery can be damaged.
The battery is supplied partially charged. Completely
charge the battery before using your power tool for
the first time. The battery can be charged at any
time without reducing its service life. Interrupting the
charging procedure does not damage the battery
a) Set the rotational direction switch (7) to the center
position in order to avoid unintentional starting.
b) To remove the battery pack (10) by pressing the
battery unlocking button (9) on both sides and
pulling the battery out of the tool.
c) To insert the battery pack (10) into the adaptor
(15), align the tongue on the battery pack with the
groove in the adaptor (15) and slip it into place.
Always insert it all the way until it locks in place
with a little click. If not, it may accidentally fall out
of the Adaptor (15), causing injury to you someone
around you. (Pic.(B)(C))
CAUTION!
WARNING!