12
5. USF-1053DDA I/O via USF-105S/AS Internal Bus
USF-1053DDA modules can input an SDI signal via USF-105S/AS frame internal bus.
USF-1053DDA modules can output an SDI signal via USF-105S/AS frame internal bus.
The number of outputs can be increased up to 10 by installing two USF-1053DDA modules into a USF
frame and using internal bus lines. Install a module pair into
Slot 1 and Slot 2
or
Slot 3 and Slot 4
on
the USF-105S/AS frame
USF-105S/AS Frame Rear Panel
A
L
A
R
M
1
2
AC100-240V 50/60Hz IN
L
A
N
1
L
A
N
A
GENLOCK
To use frame internal buses for video signal distribution, change module settings using dip switches on
the USF-1053DDA front panel or in the Web GUI page.
5-1. Slot 1 to Slot 2
5-1-1. Input Settings via DIP Switch
Set the front panel DIP switches on USF-1053DDA modules to those shown in the tables
below and install them into
Slot 1
and
Slot 2
on the USF frame.
USF-1053DDA
SW1
SW2
SW3
SW4
Uses the rear panel input.
Slot 1
ON
OFF
OFF
OFF
USF-1053DDA
SW1
SW2
SW3
SW4
Uses the Slot 1 input.
Slot 2
OFF
ON
OFF
OFF
5-1-2. Input Settings via Web GUI
(1) Install two USF-1053DDA modules into Slots 1 and 2.
(2) Start the 1053DDA Web GUI and set as follows.
Set Slot 1 Input Source to
Rear In
.
Set Slot 2 Input Source to
Slot 1
.
3G/HD/SD SDI IN
USF-1043FS
1
2
1
2
3
4
3G/HD/SD SDI OUT
SDI IN
1
2
3
4
5
SDI OUT
USF-1053DDA
SLOT 1
(USF-1053DDA)
SLOT 2
(USF-1053DDA)
