21
5-3-4. Unit ID Assignment
Click
Unit ID Assignment
in the left pane to display the Unit ID Assignment page. This page
allows you to assign Main Units to
Unit ID
numbers using IP addresses and unit names.
When controlling multiple main units, unit names can help you identify units. Up to 100 units
can be registered in the list.
(1) Move the mouse over the desired Unit ID numbers at the top of the page to display the list.
Then click on the ID numbers (
Unit 1- 20
for example).
(2) Enter an IP address (required) under the Unit ID number for each unit (FA-505, FA-1010,
FA-9520 or FA-9500) as shown above.
If a unit is not registered in the list, the message “No Assigned IP Address” will appear
when trying to connect to the unit.
(3) Enter a unit name (not required) under the Unit ID number. Units names must be
alphanumeric and within 15 characters.
Unit names are displayed on the FA-10DCCRU front panel while selecting a main unit or
after connection is established. If a unit name is not specified, the IP address will be
displayed instead of a unit name.
Change the Port (TCP port number) setting only when another device than those below
exists in the LAN and uses this port number:
FA-505 / FA-50GUI / FA-1010 / FA-10GUI /
FA-9520 / FA-9500 / FA-10RU / FA-95RU /
FA-10DCCRU
If a port number is changed, set the same number for all devices listed above.
(4) After all settings are finished, click
Apply
.
IMPORTANT
Do
not
forget to click
Apply
. When the list display or menu page is changed without
clicking
Apply
, the settings in the list are ignored and they will return to their previous
settings.
