FOR-A ADA+205A, Руководство по эксплуатации

Страница: 11 / 18

3
2-2. Rear Panel
Connectors and items located on the rear panel of the ADA-205A are as shown and described in
the figure and text below.
Where:
①
R-INPUT/MONO
Used to input right channel stereo audio signals when MODE switch is set to STEREO or
monaural signals when MODE switch is set to MONO. XLR connector (female).
②
R-OUTPUT
Used to output audio signals distributed from input connector
①
above. Outputs either 5
right channel stereo signals or 5 monaural signals. XLR connectors (male).
③
MODE selection switch
Used to select either MONO/10-OUTPUT or STEREO distribution.
MONO setting distributes 10 monaural inputs from connector
①
, STEREO setting
distributes 5 right channel stereo outputs from connector
①
and 5 left channel stereo outputs
form connector
④
.
④
L INPUT
Used to input left channel stereo audio signal when MODE switch is set to STEREO.
DO NOT
connect this input when the MODE switch is set to MONO.
⑤
L-OUTPUT
Used to output audio signals distributed from input connector
①
or
④
above. Outputs either
5 left channel stereo signals
④
or 5 monaural signals
①
depending on MODE switch setting.
⑥
R/L INPUT 600
Ω
switch
Used to select either 600
Ω
termination (ON) of R/L input or no termination (OFF).
⑦
FUSE holder
A fuse is installed.
100 / 117VAC
125V 0.3A (slow blow)
220 - 240VAC 250V 0.2A (slow blow)
⑧
Ground Terminal
Used to ground unit and protect operator from electrical shock.
⑨
AC IN
Used for connection to AC power source via supplied accessory cord.
R-INPUT/MONO L-OUTPUT
2 3 4
1 5 1
2 3 4
5
R-OUTPUT L-INPUT
MONO
10-OUT
STEREO
6 7 8 9 10
0.3A
MODE
ON OFF
R/L INPUT 600

① ② ③ ④ ⑤ ⑨ ⑧
⑥ ⑦