9
Standby Mode
The
Fontanella
will go into
Standby Mode
(also referred as
Sleep Mode
) when
Fontanella
is idle for more than
28 minutes
. This mode helps conserve and save
power when
Fontanella
is not in use. To restart, hold down the
Push Button
of the
Control Scroll
for several seconds, and the
Fontanella
will again be ready for use
(Note: It is not necessary to start
Fontanella
by pressing the
ON/OFF Button
).
Bio-Filter Water
Caution:
When starting up the unit for the first time, it is necessary to eliminate
every type of produced water (still, cold, hot and sparkling) for the first 3 litres of
production in order to eliminate the protective anti-bacterial agent introduced at the end
of the testing cycle during manufacture.
During this stage, the produced water may have an unpleasant smell and / or an
altered colour: this will disappear after the dispensing of 3 litres of water that needs
to be discarded. By pressing the
PUSH Button
on top of the
Control Scroll
, begin
dispensing water.
Bio-Filter Periodic Replacement
The
Bio-Filter
system is fitted with components that are subject to periodic
replacement. One of the most important parameters affecting maintenance is the
quality of the water (the higher the quality of the water placed in the water tank, the
longer the average life of the component). The
Bio-Filter
is provided with the
Fontanella
and filters approximately 500 litres of water before needing replacement
(depending on quality of water used).
Bio-Filter Alarm
If the
Fontanella
unit emits an audible intermittent alarm and the red LED in the left side
panel starts flashing with a softly siren, change the
Bio-Filter
located directly
underneath. Unscrew the
Bio-Filter
in the left side compartment and replace.
After replacing, dispense and discard the first 2 litres of water to eliminate the sanitizer
within the new
Bio-Filter
.
If it should continue emitting the sound and flashing after new
Bio-Filter
is placed,
please call Technical Support on 1300 881 693.
