Fonrich FR-DCMG-MMPU, Руководство пользователя

Страница: 14 / 39

14
MODBUS Protocol definition
Communication format configuration
•
Modbus communication mode: RTU mode
•
Address of the slave device: range form 1 to 247 (default 247)
•
Baud rate (bps): 2400, 4800, 9600 (default), 19200, 38400
•
Byte check mode: odd check, even check, no check (default)
Data frame format description (refer to Modbus RTU standard)
The byte in the communication frame composed by 1 start bit, 8 bits data bit, 1 parity
bit, 1 stop bit like the below table（Refer to standard modbus RTU protocol):
Table 1:
Data frame format table
Address Code Function Code Data Area Check Zone
1byte 1byte N*1byte 2bytes
The address code is used to identify the slave that receives the data frame and the
response frame sent by that slave. The function code indicates how the master requires
the slave to respond and the slave responds to that function code. Data area The content
can be the address value, the number of registers, the data from the slave response and
the data sent by the master to the slave, etc., which can hold up to 252 bytes of data. The
check area uses CRC cyclic redundancy to check whether a frame of data is wrong. The
high byte of the data frame comes first, and the low byte comes after.
Function code description
Register reads and writes in bits
•
Function code 01 used to read the contents of the bit register
•
Function code 02 used to reads the contents of the bit register
•
Function code 05 used to write single bit-type registers