ANTI-SKATING CONTROL ADJUSTMENT
Place the ANTI-SKATING control at the same value selected on the scale ring so that it corresponds to the
weight of the needle on the record. If the weight is 2 grams, the control must be set at value 2.
SPEED PITCH CONTROL ADJUSTMENT
1.- This slider allows the rotation speed to be varied in a range of ±16% for DJ effects.
2.- In order to check the speeds 33 rpm or 45 rpm, observe the series of dots on the platter lit up by the
strobe light. The dots that appear to be stationary are those that show the correct speed.
3.- If the dots move to the right, this means that the platter is going slower than the selected speed. In this
case, move the potentiometer towards ‘+’ until the dots remain stationary. If the dots are moving to the
left, the speed is faster and should be corrected by moving the potentiometer towards ‘-’ until the dots
remain stationary.
The two settings are located on the lower part of the turntable and are accessed using a screwdriver.
CONNECTION
- Connect the turntable to the power supply.
- Connect the turntable output (2 x RCA connectors) to the input of a device with phono level or line level.
Place the PHONO/LINE switch in the appropriate position depending on the type of input to be connected
to the turntable.
- If you wish, the turntable can be connected to a PC using the USB cable provided.
Note
: when the turntable is connected to the PC using the USB cable provided, the PC will recognise the
turntable as a recording device ‘
USB Audio CODEC
’.
INSTRUCTIONS FOR USE
OPERATING
1.- Depending on the type of record going to be played (33 or 45 rpm), choose the required speed with the
switch on the upper panel. If the record is a single (45 rpm), use the insert provided.
2.- Turn on the turntable with the ON/OFF switch on the rear part of the device.
3.- Remove the needle protector.
4.- Raise the cueing lever and position the tonearm over the record.
5.- Put the needle at the start of the record and lower the cueing lever. The tonearm will gently lower itself.
6.- Press the START/STOP button when you want to start or stop playback.
7.- After finishing playback, switch off the turntable with the ON/OFF switch.
- 6 -
EN
VINYL-12U_MANUAL_(EN)_20171009_Maquetación 1 10/10/17 8:11 Página 6
