FONESTAR TMRI-844, Инструкция по эксплуатации

Страница: 9 / 16

EN
- 9 -
INSTRUCTIONS FOR USE
RF CHANNEL SELECTION FOR TRANSMISSION/RECEPTION
The transmitter (hand-held microphone or belt-pack microphone) and the receiver (belt-pack in ear monitor)
must be tuned to the same channel. Select a channel that is free of interference in the receiver and select
the same channel in the transmitter. If you wish to use 2 or more transmitter/receiver monitor systems
simultaneously observe the following indications to avoid interference:
- Use radio frequency channels with the maximum separation between them. Bear in mind the carrier
frequencies of each channel, as is shown in the table below:
- It is possible to use multiple receivers ( RI-840 ) in the same channel with one transmitter.
RECHARGEABLE BATTERIES
Insert the batteries in the battery compartment respecting the polarity in it. In order to recharge the batteries
use the recharge docking station mod.
MSC-2 .
RI-840 Wireless in ear belt-pack monitor receiver with earphones
Place the receiver in the corresponding compartment in the recharge docking station MSC-2 . Remove the
plastic adapter beforehand in order to insert the wireless belt-pack transmitter. During the charging process,
the LED CHARGE indicator of the recharge docking station will light up permanently in red. When the charging
process has finished, the LED FULL indicator will light up green.
MSHT-40M Wireless hand-held transmitter microphone
Place the microphone in the compartment designed for it in the recharge docking station MSC-2 . During the
charging process, the LED CHARGE indicator of the recharge docking station will light up permanently in red.
When the charging process has finished, the LED FULL indicator will light up in green.
MSHT-45P Tie-clip microphone with wireless belt-pack transmitter
Place the microphone in the corresponding compartment in the recharge docking station MSC-2 . Remove
the plastic adapter beforehand in order to insert the wireless belt-pack transmitter. During the charging
process, the LED CHARGE indicator of the recharge docking station will light up permanently in red. When
the charging process has finished, the LED FULL indicator will light up green.
TMRI-844_TPRI-845, TSRI-841_MANUAL_(EN)_20180315_Maquetación 1 15/3/18 12:31 Página 9