FR
- 3 -
- 3 -
EN
EN
REAR PANEL
8
7
6
5
4
3
2
1
1
3
2
4 5
6
8
7
1
3
2
4
1.-
1-8
: outputs for the connection of the different devices, female Schuko connectors
2.- On/off sequencer switch.
3.- Power cable. The wires must be connected as follows:
- White wire = N (neutral).
- Black wire = L (line).
- Yellow-green wire = ground.
4.-
START AUTO REMOTE
: remote activation of the device in auto mode via contact closure. Connect a
switch to enable contact closure and activate the sequence.
INSTRUCTIONS FOR USE
MANUAL MODE
In manual mode you can individually select the outputs you want to activate/deactivate by pressing the
corresponding output selection buttons. Can detect that the active mode is in manual mode when the
START AUTO LED is off.
The LEDs of each output will turn on or off each time you press these buttons indicating that the output is
on or off respectively.
Secuencia de apagado
Secuencia de encendido
1
1
1
2
2
2
MANUAL MODE
The auto (sequence) mode allows the outputs to be activated/deactivated automatically with a fixed time
interval during sequence programming. Switching on will always be in increasing order (1, 2, 3...) and
switching off in decreasing order (8, 7, 6,...).
Secuencia de apagado
Secuencia de encendido
1
1
1
2
2
2
To program the sequence, follow these steps:
- With the START AUTO indicator light off, press the + or - button to start the programming mode At this
moment, the LED of the last set output will be flashing.
- Select the output you want to configure with the direct selection button, then select the desired time
interval using the +/- buttons: between 1 (0.5 seconds) and 9 (4.5 seconds) for automatic on/off, or 0 to
disable auto mode on this output.
NOTE:
by default, All outputs will be set to 2 (1 second).
- If you wish to set the delay for the other outputs, press the select button for the output you wish to set
