FONESTAR MAZ-4160, Инструкция по эксплуатации

Страница: 6 / 11

CONNECTION
Make the connections with the amplifier and all the audio system components switched off and disconnected
from the power supply.
Firstly, connect the audio sources to the inputs. For example, connect a dynamic microphone to the CH1
input and select the position MIC on the input sensitivity selector. If using a preamplified table microphone,
select the LINE position.
Connect the speakers to the speaker output. Use the low impedance (4-8 Ω) output or the 100, 75 or 25 V
high impedance line output, according to the type of speakers that you are going to connect. Do not use both
types of output at the same time.
If using the low impedance output, you must connect the speakers in a series/parallel circuit so that the
speaker load impedance is the same as the amplifier impedance and that the power supplied by the amplifier
does not exceed what is withstood by the speakers.
If using the 100, 75 or 25 V high impedance line output you must connect all the speakers in parallel and the
sum of the power of all the speakers must not exceed the power supplied by the amplifier.
Once all the connections have been made according to your needs, connect the equipment to the mains and
switch them on. After use, do not forget to switch them off and disconnect the equipment from the mains.
Example of 100 V line high impedance connection
- 6 -
EN