Fondital IST 03 F 014 - 02, Руководство по установке и обслуживанию

Страница: 9 / 12

9
Comfort Mode
This is the normal mode for using the radiator to keep the room temperature at the programmed level. The programmed temperature depends on
the position of the temperature control (knob 2).
As an indication, the programmed temperature and the numbers shown on the knob correspond to the values shown in pic. 3:
When set at the angle between 0º and 9.5º, the programmed temperature is around 7ºC.
fig. 3
Night-time reduction mode:
When the mode control is in this position, the programmed temperature will be 3.5ºC lower than the temperature programmed on the
temperature knob at that time.
Anti-freeze mode:
When this mode is selected, the programmed ambient temperature is 7ºC.
Off mode:
When the mode control is in this position, the radiator is turned off. The LED light is off.
NB: The radiator is still pulling power in this position.
Pilot wire mode:
This mode enables the user to control the radiator from a remote control unit.
The temperature setting will depend on the pilot wire controls and the position of the temperature potentiometer.
This mode can be only used in radiators installed in France.
7. CLEANING THE RADIATOR
For safety reasons, disconnect the power supply before cleaning the appliance.
Cleaning must be done when the radiator is turned off and is cold.
Do not use abrasive or corrosive products to clean the heating appliance: use soapy water, for example and dry the body with a soft cloth.
Clean plastic parts, controls and the humidifier with a dry cloth only and avoid contact with chemicals or alcohol.
Summary of operating modes:
Mode Description
OFF:
The radiator is turned off but pulling power
Comfort:
The room temperature is regulated based on the value programmed using the temperature knob
Night-time reduction:
The programmed temperature is 3.5°C lower than the temperature programmed on the temperature knob.
Anti-freeze:
Minimum safety temperature: a fixed value of 7ºC is kept.
Pilot wire (for France only):
The temperature depends on the pilot wire control.