Fomotech Alpha 600XJ Series, Руководство по эксплуатации и запасным частям

Страница: 37 / 49

- 36 -
A
B
C
D
E
F
8
8
.
.
T
T
R
R
A
A
N
N
S
S
M
M
I
I
T
T
T
T
E
E
R
R
O
O
P
P
E
E
R
R
A
A
T
T
I
I
O
O
N
N
&
&
S
S
T
T
A
A
T
T
U
U
S
S
L
L
I
I
G
G
H
H
T
T
8.1 Transmitter Operating Steps
1.
Battery replacement steps
For induction charging, please use two
“
AA
”
low self-discharge NiMH (Nickel
Metal Hydride) Batteries.
A. Screw open the battery cover.
B. Pull up the ribbon (to take out the exhausted batteries)
D. & D. Put and press the first battery into the battery compartment. (Note the polarity and position)
E. & F. Put and press the second battery into the battery compartment. (Note the polarity and position)
2. Status lights _To operate the transmitter, please rotate the power key on the top-left corner clockwise
to
“
on
”
position. The status LED (green and red) will be steady
“
on
”
for 2 seconds and then
“
off
”
. If
the transmitter Status LED displays a red blinking light that is
“
on
”

0.1 second and
“
off
”

1.9
seconds, or no light at all, this indicates the transmitter with batteries needs to be recharged. For
battery charging or replacement, please refer to instruction next page.
3. When any function pushbutton is depressed, the transmitter Status LED displays a red blinking light
that is
“
on
” 
0.1 second and
“
off
” 
1.9 seconds. If the voltage is low, the transmitter Status LED
will be
“
on
”

0.1 second and
“
off
”

1.9 seconds, this indicates the transmitter with batteries needs to
be recharged. Continuous operation will cause the transmitter battery power exhausting and cannot
operate at all.
4. EMS & Restarting _ In case of an emergency, press down the red emergency stop button (EMS) will
immediately deactivates the transmitter and receiver MAIN relay (Do not first switch off the power
key in case of any emergency).
5. The emergency stop button is a right-rotate momentary spring-return type. To turn on the transmitter
and activate the MAIN relay, please elevate the emergency stop button again and rotate the
transmitter power key to
“
ON
”
position.
6. Note that the transmitter cannot be hit by outer force, so that malfunction can be prevented.
7. The operating temperature is -10 ~ +60
℃
. Avoid operating the transmitter in high temperature
workshop. If operating temperature is higher than 80
℃
, the auto shutdown protection installed inside
CPU will shut down the transmitter and deactivate the MAIN relay.