Folyon H300, Руководство пользователя

Страница: 2 / 15

H300 Temperature Humidity Chamber
Page 2
Introduction
The H300 is a simple to use, versatile temperature / humidity chamber. Its super compact design allows it to
be placed on any table top. Its solid state design means low noise and low power operation. The solid state
design also removes the need for user maintenance other that refilling water and desiccant.
The H300 comes in four configurations:
• H300 : Simple set point control for temperature and humidity
• H300RT : Profiling control for temperature, simple set point control for humidity
• H300RH : Simple set point control for temperature, profiling control for humidity.
• H300RTH : Profiling control for both temperature and humidity.
A profiling controller allows the user to setup a program for the chamber to follow. For instance: Goto
50%RH at 1%RH per minute, stay at 50%RH for 30 minutes, go to 75%RH as fast as possible, stay at 75%RH
for 1 hour, etc.
Safety Instructions
Follow all CAUTION notices to prevent damage to the chamber. Failure to follow all CAUTION notices may
void your warranty.
WARNING indicates a potentially hazardous situation which, if not avoided, could result in death or serious
injury.
The safety alert symbol precedes a general CAUTION or WARNING statement.
The electrical hazard symbol precedes an electric shock hazard CAUTION or WARNING statement.
Installation Safety Notices
WARNING : The power cord is equipped with a NEMA 5-15P grounded GFCI plug. To prevent a shock
hazard, DO NOT defeat the ground or GFCI features. This device MUST be plugged into a
properly grounded receptacle.
CAUTION
: The minimum clearance you should allow for proper ventilation around the chamber must be
at least 6" from the rear, and 3’’ from both the left and right side.
CAUTION
: This chamber is designed for operation in a conditioned laboratory environment. Operation
above 30°C (85°F) or below 16°C (60°F) ambient room temperature is NOT recommended.