CAUTION!
§
Do not tilt unit further than 30° off vertical during uncrating or installation.
§
Dispenser bin area contains mechanical, moving parts. Keep hands and arms clear of this area at all times. If access to this
area is required, power to unit must be disconnected first.
§
This appliance is not suitable for installation in an area where a water jet could be used.
§
This appliance must not be cleaned by a water jet.
§
User maintence should not be done by children.
§
Follett recommends a Follett water filter system be installed in the ice machine inlet water line (standard capacity #00130229,
high capacity #00978957, carbonless high capacity #01050442).
§
Prior to operation clean the dispenser in accordance with instructions found in this manual.
§
Do not block air intake or exhaust.
§
This appliance should be permanently connected by a qualified person in accordance with application codes.
§
A qualified person shall provide a readily accessible disconnect device incorporated into the fixed wiring.
§
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.
§
This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory, or mental
capabilities, or lack of experience and knowledge if they have been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved. Children should be supervised to ensure that they do not play
with the appliance.
§
This appliance is designed for commercial use.
§
WARNING! To avoid a hazard due to instability of the appliance, it must be fixed in accordance with the instructions.
§
Warranty does not cover exterior or outside installations.
§
To reduce risk of shock, disconnect power before servicing.
§
Connect to potable water supply only.
§
Ice is slippery. Maintain counters and floors around dispenser in a clean and ice-free condition.
§
Ice is food. Follow recommended cleaning instructions to maintain cleanliness of delivered ice.
Specifications
Electrical
§
Each ice machine and dispenser requires a separate circuit with electrical disconnect within 10 ft (6 m).
§
Equipment ground required.
§
Standard electrical – 230 V, 50 Hz, 1 phase or 220 V, 60 Hz, 1 phase
§
Connect to a dedicated circuit.
§
Maximum ice machine amperage – 5.5A.
§
Cord provided on ice machine.
Plumbing
§
3/8" FPT water inlet
§
3/4" MPT drain
§
3/8" FPT condenser inlet (water-cooled condenser only)
§
3/8" FPT condenser drain (water-cooled condenser only)
Notes:
§
Slope to drain of 1/4" per foot (20 mm per 1 m run) with a 1/2" min. is recommended.
§
Water shut-off recommended within 10 feet (3 m), drain to be hard piped and insulated.
§
Separate drains for ice machine and condenser. To prevent back flow, do NOT connect drains.
§
Follett recommends a Follett water filter system be installed in the ice machine inlet water line (standard capacity
#00130229, high capacity #00978957, carbonless high capacity #01050442).
2
MC_425A/W, MM_425A/W, MF_425A/W, _P425A/W Ice Machines
