Follett E7CI100A, Инструкция по установке, эксплуатации и обслуживанию

Страница: 10 / 40

10 Dispenser and Ice machine E7CI100A/E7FS100A
Installation
(continued) ––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
9. Secure unit to wall or cove molding with supplied bracket (Fig. 7) to
prevent tipping.
Note: Fasteners must be supplied by installer.
WARNING!
Freestanding unit must be secured to wall to prevent
tipping. Failure to do could result in personal injury or
damage to the unit.
Fig. 7
Optional Leg Accessory Installation
1. If installing optional 6" (15.24 cm) Leg Accessory (item#
00956318), tilt or lay base stand on side and screw each leg
into stand
(Fig. 8) .
Fig. 8
Optional Internal Water Filter Installation
If your dispenser has the internal water fi lter option, the water fi lter must
be installed for the dispenser to operate. Because internal components
will need to be accessed for both procedures, Follett recommends
installing the water fi lter just prior to initial sanitizing.
1. If installing the optional internal water fi lter, please complete
the steps shown in
Accessing Internal Components on page
11 before proceeding.
2. Lift and remove the top panel, set aside (Fig. 9.1) .
3. Remove two screws (Fig. 9.2) and remove left side panel.
4. Install fi lter as shown. Turn fi lter clockwise until it is fully seated
(Fig. 9.3 ).
Fig. 9
1
2
3