Undercounter Dispenser and Ice machine 7UC100A/7UD100A 11
Cleaning and Sanitizing –––––––––––––––––––––––––––––––––––––––––––––
Cleaning and sanitizing should be performed at least every 6 months (more often if
local water conditions dictate) . For initial startup, only sanitizing is required .
IMPORTANT! Prior to cleaning and sanitizing, the dispenser must be moved
forward at least 4" (10 .16 cm) . Do not remove the Bin Lid, cleaning and sanitizing
solution is added through the Bin Lid Access Spout
(Fig . 9 .6) .
WARNING!
§
Place the dispenser in Maintenance Mode prior to servicing or
cleaning the ice machine. See
Maintenance/Cleaning Mode on page
.
§
For protection, rubber gloves and safety goggles (and/or face shield)
should be worn when handling cleaner/sanitizer.
§
Do not use bleach, it will damage the dispenser.
Required Supplies
§
21 oz . (0 .621 L) or 3 packets Urnex brand cleaner/sanitizer
§
Nu-Calgon IMS-II sanitizing concentrate
§
Funnel and Bucket
Cleaning and Sanitizing: Ice machine and Dispenser
1 . Dispense all the ice out of the unit .
2 . Press and hold maintenance/clean switch until
displays in the user
interface to enter Maintenance Mode .
3 . Remove (unscrew) chrome ice dispense chute (Fig . 9 .1) .
4 . Remove drip tray (Fig . 9 .2) .
5 . Remove (2) screws located behind the drip tray (Fig . 9 .3) .
6 . Move front panel and place on top or beside unit (Fig . 9 .4) .
7 . Remove plug cap from the end of drain tube (Fig . 9 .5) and lower tube to
drain water into bucket .
Fig . 9
1
2
3
4
6
5
7
8 . After the system has been drained of water replace plug cap in drain tube . Secure tube in holder .
9 . Remove cap from bin lid cover (Fig . 9 .6) .
10 . Screw bin lid cover cap onto ice discharge chute (Fig . 9 .7) .
11 . Mix 21 oz . (0 .621 L) or 3 packets Urnex brand cleaner/sanitizer with three gallons (11 .4 L) of water .
12 . Pour cleaning solution into bin lid access spout until solution reaches the spout neck .
13 . Allow the solution to remain in unit for 15 minutes .
14 . While machine is cleaning, remove top and right side panel to access and clean air-cooled condenser .
15 . Submerge ice dispense chute in the remainder of solution for 2 minutes . Rinse with clean, potable water .
16 . Drain system by lowering drain tube into bucket .
17 . Secure drain tube into holder .
18 . Fill one time with potable water and drain with tube . Secure drain tube .
19 . Place a bucket under the dispense chute and remove cap . Note: Some sanitizing solution will remain and
drain out when cap is removed . Reposition cap on bin lid spout .
20 . Reinstall front panel, ice dispense chute, and drip tray .
21 . Press and hold maintenance/clean switch to exit Maintenance Mode .
Urnex is a registered trademark of Urnex Brands, Inc .
Содержание E01087
