Follett 7CI100A, Инструкция по установке, эксплуатации и обслуживанию

Страница: 19 / 48

7CI100A/7FS100A, 15CI100A/15FS100A 19
21. Remove and discard mating ring and seal (Fig. 23.1).
22. Carefully remove auger (Fig. 23.2).
WARNING!
Use caution when removing auger. The auger is very
sharp - handle with care to avoid personal injury.
Fig. 23
1
2
Evaporator Assembly
1. Remove and inspect main housing O-ring seal. Replace if
damaged in any way.
2. Clean O-ring groove. Lubricate O-ring with Petrol-gel and
reinstall.
3. Use cardboard disc to press new mating ring into main
housing
(Fig. 24.1).
4. Lube the shaft with liquid soap in the area shown
(Fig. 24.2) and slip on seal and spring (Fig. 24.3).
Note: Do not touch the sealing surfaces with bare hands.
Contact with bare skin will cause premature seal failure.
5. Install auger (Fig. 24.4).
Fig. 24
Cardboard
disc
Do NOT
touch!
1
3
4
2
6. Install main housing:
§ Slide main housing onto auger shaft
(Fig. 25.1).
§ Install three M6x25 allen screws
(Fig. 25.2).
§
Connect vent line to T fitting (Fig. 25.3).
Fig. 25
1
2
3