Foley 622 SO, Руководство оператора

Страница: 23 / 32

23
- ORIGINAL INSTRUCTIONS -
OPERATION
LOAD THE CUTTING UNIT
SET THE HEIGHT
1. Place the REEL HEIGHT guage on the edge of the table next to the
reel.A. See FIG. 9.
2. Unlock the LOCK HANDLE on the left side of the HEIGHT
ADJUSTER (see FIG. 10).
3. Select the DIRECTIONAL PIN setting on the ratchet (see FIG. 10)
4. Adjust the HEIGHT ADJUSTER up or down until the the bottom of
the reel is at the same level as the top of the REEL HEIGHT gauage
(see FIG. 9).
5. Re-lock the LOCK HANDLE on the HEIGHT ADJUSTER (see FIG. 10).
6. Clamp the front roller (see FIG. 11).
7. Remove and store the REEL HEIGHT guage .
v-blocks front TOOLING rear roller clamp LOCK KNOB
T-HANDLE
1. Place the rear roller of the cutting unit into the V-BLOCKS (as shown above) . It may be necessary to
move the FRONT HEIGHT ADJUSTER into a position to receive the front roller. This is done by unlocking
the LOCK HANDLE and sliding the FRONT HEIGHT ADJUSTER in or out in order for the front roller of the
cutting unit to be placed on the FRONT HEIGHT ADJUSTER.
2. When the front and rear rollers are in position, clamp the rear roller with the REAR ROLLER CLAMP. The
REAR ROLLER CLAMP rotates 90° (by turning the T-Handle) when placed on the rear table.. Once placed,
lock the LOCK KNOB by pushing down towards the table.
FIG. 11
FIG. 10
HEIGHT ADJUSTER
directional pin
NOTE: The FRONT CLAMP and FRONT TOOLING may need to be adjusted in or out in order to avoid
interference with the grinding head. The FRONT TOOLING slides in or out by unlocking the LOCK HANDLE and
pushing or pulling on it.
CLAMP front roller