CARE AND MAINTENANCE
General cleaning
After turning on,follow the instructions below to complete a Custom Temp setting:
1. Press Custom Temp key to activate
Custom Temp setting. (You will see the
actual temperature value blinks for a
while.)
Custom Temp
2. Rotate the PROGRAM knob to
adjust the required temperature
3. Pree START CANCEL button to start
heating.
1.When the kettle is on,press and hold the“
CUSTOM TEMP”button for 3 seconds
to enter the MUTE mode.Mute icon
is on.In Mute mode, there won't be
beep sound and key tone.
2.Press and hold “CUSTOM TEMP” button
for 3 seconds to quit Mute mode .
Mute Mode
We recommend cleaning the kettle after using each time.
1. Unplug the power base from the electrical outlet.
Descaling the Kettle
You should descale the kettle at least once a week if you use it frequently.
Descaling removes any mineral deposits that have built up inside the kettle.
Always descale the kettle after it has been stored for long periods of time and
before storing it.
1. Fill the kettle with 1 cup of distilled vinegar or lemon juice and 2 cups of water
(1:2 ratio).
2. Boil the mixture, then let it soak in the kettle for 2 hours.
3. Pour out the solution, then wipe the limescale away with a cloth or nonabrasive
sponge.
4. Rinse the kettle with clean water, and dry with a soft cloth.
5. Repeat as needed.
TROUBLESHOOTING
Problem
Easy solution
Kettle will not
switch“ON”
The kettle will
not work
1. Check the power plug if is securely inserted into the outlet.
2. Insert the power plug into an independent outlet.
3. Insert the power plug into a different outlet.
4. Reset the circuit breaker if necessary.
5. For additional safety, the kettle is fitted with a thermal cut out. In
the event of severe
overheating, the kettle will be automatically shut down to prevent
furthe damage. If this occurs,please call Consumer Support.
Check the glass jug if is securely positioned on the Power Base.
The LCD light
has gone out
1.The kettle goes into standby mode if not used for 5 minutes. When
in standby mode, the LCD screen will cease to illuminate.
2. To re-activate the kettle out of standby mode,Press Main button
on the Power Base.
I cannot select
a certain function
Certain features cannot be selected or changed during the
heating or brewing cycle.The LCD screen may temporarily change
or send a sound alert
2. Allow the kettle to completely cool down, then pour out any remaining water.
3. Wash the kettle with warm, soapy water. Dry it thoroughly with a soft, clean
towel.
09
10
