Equipment Setup
The hose and nozzle assembly of the 7807 Noz-L-Jet is shipped in a
separate carton, and must be attached to the power head.
Attaching the 7807 Noz-L-Jet hose/wand assembly
From the open hose end of the hose/wand assembly, gently stretch
out the internal tube to access the “push to connect” male fitting. The
tube carries liquid to the nozzle.
On the power head, extend the liquid connector and insert male fit-
ting fully. (For disassembly instructions, see Maintenance).
Attach hose to power head. Loosen hose clamp, slide hose firmly
over air discharge opening, and retighten hose clamp to secure.
Set-up for all models.
Loosen tank clamps and remove power head from tank. Remove
extra plastic tank liners from tank.
Open a protective plastic tank liner and position it inside tank (new
units ship with a tank liner in place). The top of the liner should extend
over and outside the top lip of the tank.
Add fogging liquid to the tank (inside the tank liner). Confirm that
the tank gasket is in place inside the lip of the cover plate. Put the power
head on the tank and fasten clamps to secure it.
Install the air intake filter over the air intake. Attach to “hook &
loop” dots at the 10 and 2 o’clock positions on the housing, then stretch
filter down and anchor over bottom of air intake.
Plug the fogger power cord into a grounded (earthed) outlet and
turn power switch ON.
Adjust liquid valve for the desired fog droplet size characteristics
[some models do not have a flow control valve]. On the 7401, push the
red ring of control valve in to lock valve setting (out to release).
On the 7807, depress the fog control valve on the wand; latch valve
handle up for continuous output.
8
