6
INTRODUCTION
Thank you for purchasing the Focusrite RedNet MP8R.
RedNet MP8R is an 8-channel remote-controlled microphone preamplifier and A/D for the Dante
audio-over-IP network. Specifically tailored for the road, live-sound and broadcast environments,
each unit features network and power redundancy, rugged construction with latching connectors,
remote control and remote monitoring. In addition, a gain-compensated split output is available on
every channel
(see following page for further detail)
.
Eight remote-controlled Focusrite mic preamps and precision A/D conversion at up to 192kHz/24-
bit with minimum latency.
Dual Ethernet connectors (primary and secondary) on the rear-panel allow maximum network
reliability with seamless switchover to a standby network in the unlikely event of a network failure.
These ports may also be used to daisy-chain additional units when operating in Switched mode.
Separate power input sockets on the rear panel allow one supply to be connected to an uninterruptible
source. Each PSU’s status can be monitored remotely over the network or from the front panel.
Audio input uses locking XLR3F connectors on the rear panel.
Rotary gain control with OLED level display for indication of gain settings and system information.
A Select button plus 6-segment level meter is provided for each channel. Individual buttons for the
selection of input impedance, 20dB Pad, 48V phantom power, high-pass filter and polarity inversion
are included on the front panel.
Channels can be remotely controlled via the RedNet Control software package, Pro Tools and MIDI,
or OCA (Open Control Architecture) with future firmware updates.
The front panel contains a set of LEDs to confirm network status, sample rate and clock sources as
well as each mic amp’s input and gain settings.
