Focusrite Green Range, Руководство пользователя

Страница: 15 / 22

Using the Low and High Eq
Low and High Eq are often used to correct problems with a signal:
To compensate for a lack of something in the original recording (for example, if
you had to roll off a lot of bass during recording because you were getting a lot of
bass lift)
To replace something you lost in the recording format (particularly top end)
To reduce something excessive (such as a very bassy sound)
Use the Low Eq to boost subsonic information, thus giving a bassy sound, or to
attenuate a sound that is too bassy.
Use the High Eq to boost ambience and reverb in a room, or to attenuate an over-
bright sound.
Mid Eq
The Mid Eq gives you control over the vocal frequency spectrum. Unlike the High and
Low Eq, the Mid Eq affects only a band of frequencies around a selected frequency.
The width of the band of frequencies affected is determined by the Notch control.
Controls
The Mid Eq lets you set every parameter: the gain or attenuation, the frequency
affected, and bandwidth. (see following diagram)
v o i c e b o x
16
Notch
Hz
dB
18
18
11
3.5
3.5
11
+
–
Mid Eq
6k
300
550
990
1k8
3k8