Remove the frame panel from any pro-
tective packaging. Ensure all/any pro-
tective film is removed as the facia may
be damaged if the fire is lit with the
facia in position whilst still covered in
film.
To remove the frame panel, first,
remove the retaining cap head screws
(one on each side of the appliance).
Simply lift the frame upwards. Refitting
is the reverse of removal. Ensure the
cut-outs in the bottom of the frame
support brackets engage the lower cap
head screws on each side of the appli-
ance.
All instructions must be handed to the user for safekeeping. Show the customer how to light and control the fire.
After commissioning the appliance, the customer should be instructed on the safe use of the appliance and the need for regular
servicing. Frequency of service depends on usage, but MUST be carried out at least once annually.
Advise that cleaning of the fire may be achieved when the fire is cold using a damp cloth and mild detergent on most surfaces.
Advise that on first light up of a new appliance, initial curing of high temperature paint and burning off of lubricants may occur for
the first few hours of operation. During this period some smoke may be emitted from the outlet grille, this should be no cause
for concern. Accordingly, the room should be well ventilated with all windows and doors open during this period. During this
period the appliance may cause smoke alarms to sound. If this happens, reset the alarms, but do not remove the batteries.
Recommend that a guard be used for the protection of the young, pets, the elderly and the infirm.
Advise the customer that the ventilation openings should not be blocked or obstructed in any way.
Isolate the fire from the gas supply. Ensure that the fire is fully cold before attempting service.
A suggested procedure for servicing is detailed below.
8.3 FITTING THE DECORATIVE FRAME ASSEMBLY
9.0 BRIEFING THE CUSTOMER
10.0 SERVICING
Figure 9
1. Lay out the dustsheet and tools.
2. Remove the decorative frame/glass facia assembly. Removal is reverse of section 8.3.
3. Remove the glass door assembly (4 screws) and clean carefully.
4. Inspect the burner and the catalyst and clean if necessary with a soft brush.
5. Disconnect the gas supply.
6. Undo the four screws retaining the burner support brackets to the base and rear of the firebox. Remove the control knob
and spindle assembly from the valve by removal of the spindle retaining clip.
7. Remove the burner unit, strip off the burner pipes and clean thoroughly.
8. Clean the in-line restrictor, pilot assembly and the burner tube. Do not attempt to remove the pilot injector as this can cause damage.
9. Re-assemble components.
10. Turn on the gas supply and leak test. Check pilot and burner for good ignition.
11. Refit the glass door assembly, ensuring correct orientation and a good seal.
12. Refit the decorative facia/frame assembly as detailed in section 8.3.
13. Check the purpose provided ventilation is un-obstructed.
14. Light the fire and test setting pressures.
15. Check safe operation of the appliance by performing a combustion test as detailed in section 10.3.
For specific servicing instructions, see relevant sections.
7
'
2015 Focal Point Fires plc.
GB IE
1.Remove retaining
cap head screws
2.Lift frame away
from supporting pins
