The control knob is located on the lower right hand side of the outer case. It is marked as shown in figure 4.
The pilot is visible behind the left hand side of the burner.
Push the control knob in fully and turn anti-
clockwise through both of the SPARK positions, keeping fully depressed, hold there for a few seconds.
If the fire has not been used for some time, hold the knob in this position for longer, to allow any air
in the pipes to be purged. Continue turning anti-clockwise through the spark clicks to the nine o’clock
position, ensuring the pilot has lit. If not, return the knob clockwise, and repeat. When the pilot lights
after one of the two sparks, keep the knob depressed in the nine o’clock position for approximately
ten seconds. Now release the knob and the pilot should stay alight. If the pilot is extinguished during
use, wait three minutes before repeating the ignition procedure. To achieve the HIGH setting, push
the control knob in slightly and continue turning anti-clockwise to the high position. The main burn-
er should light after a few seconds. To decrease the setting to LOW, push the knob in slightly and turn
the control knob clockwise to the low setting. To turn to the pilot only position from the HIGH or
LOW positions, press the control knob in, and return to the nine o’clock position and release. To turn the fire OFF, keep the knob
pressed in, return to the off position and release.
This fire is fitted with a combustion monitoring safety device (ODS). If the appliance shuts down during use for no apparent rea-
son then several reasons may be suspected. If a door or window has been opened creating a draught, then pilot disturbance could
be the problem and removal of the draught should resolve this. The appliance can then be re-lit in accordance with the previous
section. If pilot disturbance is not the cause, then the ODS safety system may be in operation. Switch the appliance OFF, call in
your installer to check the appliance and ventilation. Remedial work must be carried out as required. DO NOT allow the appli-
ance to be used until the appliance and installation is passed as safe. If the pilot continues to be extinguished, you must call your
installer to check the operation of the complete appliance.
Before carrying out any of the following operations, ensure that the appliance is OFF and completely cold. Regularly clean around
the appliance to ensure that dust, fluff, pet hair etc, are kept to a minimum. There are no other specific requirements for care,
other than regular cleaning of the general appliance.
A wipe with a dry cloth is normally sufficient. DO NOT use abrasive cleaners as they can damage the finish. Metal parts may be
cleaned using an appropriate metal cleaner. Test on a hidden part before cleaning. Clean only in the direction of the grain.
GLASS PANEL - This can be cleaned with a suitable glass cleaner. Test on a small area first.
PAINTED AREAS - These can be cleaned using a dry cloth.
The appliance should be checked on an annual basis to ensure it is working safely and that there is no excessive build up of soot.
The frequency of service will depend on usage, but MUST be carried out at least once annually. Servicing must be carried out by
a GAS SAFE registered person.
The Installation instructions carry full servicing details for the use of the installer.
PART NO.
ITEM
F960003
Inner glass door assembly
F730023
Pilot assembly - Natural gas models (OP9082)
F730048
Pilot assembly - LPG models(Seagas P5-19)
F730086
Gas valve
TRAY111
Burner unit (Natural gas models)
TRAY120
Burner unit (LPG models)
F780079
Catalyst
(seal kit must also be supplied)
F940136
Seal kit for Catalyst
5.0 OPERATING THE APPLIANCE
‘OFF’ position
‘SPARK’ position
‘LOW’ position
‘HIGH’ position
Figure 4
6.0 COMBUSTION MONITORING SYSTEM
7.0 CLEANING
3
'
2015 Focal Point Fires plc.
GB IE
8.0 SERVICING
9.0 LIST OF REPLACEMENT PARTS
