4.0 ASSEMBLY
4
GB IE
© 2015 Focal Point Fires plc.
Fixings
Parts
B x 9 PCS
1
C x 12 PCS
2
3
4
5
STEP 3
If using option A only. If rebates are not being used go to section 5.
If a 75mm rebate (4) is required. CAREFULLY! lay the surround on a soft flat surface, taking extra care that you do not scratch
the front of the surround. NEVER DRAG THE SURROUND! Insert the 12x wooden dowels (C) into the rear of the top panel
(1), the left leg (2) and the right leg (3). With the rebates (4) in the correct orientation, place the 3x rebates (4) into position
over the wooden dowels (C). Screw the 9x 8x 45mm screws (B) through the rear of the rebates (4) connecting them to the
surround.
5.0 INSTALLATION
With a pencil mark out the desired height where you would like the mirror brackets (G) to be situated on the rear of the legs. To avoid
splitting the leg, pre drill the bracket holes with a 2mm drill bit. Now attach the brackets to the legs using the screws (D). Once the
brackets are in position, centre and level the hearth into its final fitting position. Position the surround on the hearth to correspond with
the header/fireplace lintel, mark with a pencil on the wall where you wish to drill. Remove the surround and prepare the wall from the
marked positions. If using the fixings supplied, drill a hole in the wall using a 6mm drill bit. If not, use a suitable drill bit for the wall plugs
you are using. Insert the wall plugs (F) into position. Offering the surround back up into position against the wall, you are now able to
secure the surround to the wall using the screws (E).
Fixings
D x 4 PCS
E x 2 PCS
F x 2 PCS
G x 2 PCS
①
②
③
⑤
⑤
⑤
⑤
