CONTENTS
PRELIMINARY NOTES
The Monet, Trinity and Ebony electric wall heaters provide convected heating in conjunction with a visual fuel
effect display. The three models differ only in respect of the design of the decorative front frame.
The appliance is designed for indoor use, and can be simply wall mounted in the majority of wall positions antic-
ipated. It can can be located in any household room, with the exception of bathrooms.
• Read all of the instructions before commencing installation. Retain for future reference and pass on as neces-
sary to subsequent owners of the appliance.
• DO NOT use this appliance immediately below a fixed socket outlet.
• DO NOT use this appliance in the immediate vicinity of a bath, shower, swimming pool or other area where
water/moisture could present a hazard.
• CAUTION: This appliance must not be used in conjunction with any timer, programmer or thermal control,
or any other device that will switch on the appliance automatically, as a fire risk may occur if the heaters are acci-
dentally covered or displaced.
• Note: The heater outlet is located on the top surface behind the front frame.
• Do not allow the heater to be covered as this may cause overheating. Additionally, DO NOT place any items
on top of this appliance. The appliance must not be placed near curtains or similar material. A clearance space
of at least 500mm should be allowed in front of the appliance.
• The electrical socket that the appliance uses MUST be easily accessible. Do not route the supply cord direct-
ly over or above the heater unit. If the cord is damaged, it must be replaced by a service agent or competent
person.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or men-
tal capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction con-
cerning use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
APPLIANCE DATA
ELECTRICAL INSTALLATION REQUIREMENTS
The appliance is designed to be wall mounted using the brackets and fixings provided.
DO NOT RECESS ANY PART OF THE APPLIANCE.
The appliance is supplied with a pre-wired three pin BS1363 plug (13 Amp fuse rated), and 2 metre
cable. A standard switched outlet/wall socket, (including earth provision), must therefore be located
within this distance, and be easily accessible in order to isolate the supply for maintenance and clean-
ing. This socket
must not be mounted behind or above the appliance.
IMPORTANT: THIS APPLIANCE MUST BE EARTHED.
1
Section Contents
Page No.
1.0
Preliminary Notes
1
2.0
Appliance Data/Specifications
1
3.0
Electrical Installation Requirements
1
4.0
Site Requirements
2
5.0
Clearances to Combustible Materials
2
6.0
Unpacking the Appliance
3
7.0
Component Checklist
3
1.0
Section Contents
Page No.
8.0
Preparing the Appliance
3
9.0
Fixing the Appliance
4
10.0
Operating the Appliance
5
11.0
Safety Cut-Out System
5
12.0
Maintenance - Lamp Replacement
6
13.0
Cleaning
6
14.0
Servicing
6
Weight (kg):
10.0 kg
Dimensions (mm):
H 585 x W 500 x D 133
Voltage (Volts):
230-240V a.c. 50Hz
Heating Elements:
2 x 900/1000 Watts
Supply Cord:
2 metres
Supply Plug:
BS 1363, 13A Fused
Location:
Indoor Use
Lighting:
1 x 60W Amber B.C. Bulb
2.0
3.0
