FITTING THE DECORATIVE FRAME ASSEMBLY
Remove the decorative frame assembly from
any protective packaging, and remove any pro-
tective film that may be present on the frame.
The frame is hung onto the firebox via the two
upper hanging brackets and then secured to
the firebox via the two lower knurled fixing
bolts, which are inserted through the holes in
the lower frame mounting brackets after the
frame is in position. See diagrams to the right
and below.
BRIEFING THE
CUSTOMER
All instructions must be handed to the user for
safekeeping. Show the customer how to light and control the fire.After commissioning the appliance, the customer
should be instructed on the safe use of the appliance and the need for regular servicing. Frequency of service
depends on usage, but MUST be carried out at least once annually. Advise that cleaning of the fire maybe achieved
when the fire is cold using a damp cloth and mild detergent on most surfaces.Advise that the fire will emit a "new-
ness" smell for a time after initial commissioning and that extra ventilation may be needed during this time.
Recommend that a guard be used for the protection of the young, pets, the elderly and the infirm
SERVICING
Isolate the fire from the gas supply. Ensure that the fire is fully cold before attempting service. A suggested proce-
dure for servicing is detailed below.
1. Lay out the dustsheet and tools.
2. Remove the decorative frame assembly. Removal is reverse of section 8.4.
3. Remove the glass door assembly (4 screws) and clean carefully.
4. Inspect the burner and the catalyst and clean if necessary with a soft brush.
5. Disconnect the gas supply.
6. Detatch the burner front cover plate by removal of the four retaining screws. Undo the four screws
retaining the burner support brackets to the base and rear of the firebox. Remove the control knob
and spindle assembly from the valve by removal of the spindle retaining clip.
7. Remove the burner unit, strip off the burner pipes and clean thoroughly.
8. Clean the in-line restrictor, pilot assembly and the burner tube. Do not attempt to remove the pilot
injector as this can cause damage.
9. Re-assemble components.
10.Turn on the gas supply and leak test. Check pilot and burner for good ignition.
11. Refit the glass door assembly, ensuring correct orientation and a good seal.
12. Refit the decorative facia/frame assembly as detailed in section 8.4.
13. Check the purpose provided ventilation is un-obstructed.
14. Light the fire and test setting pressures.
15. Check safe operation of the appliance.
For specific servicing instructions, see relevant sections.
7
9.0
10.0
8.4
©
2007 Focal Point Fires plc.
