Disconnect the appliance from the mains supply.
Leave the door to the freezer compartment open. You can place a bowl of warm water inside the freezer compartment to speed up
to defrost process.
Once all the ice that has built up has melted then inside of the freezer compartment should be dried thoroughly. Failure to do this
will result in immediate ice build-up when the appliance is turned back on.
With dry hands, reconnect the appliance to the mains supply. Set the temperature display to it’s maximum setting or switch on the
super frost setting for 24 hours.
You should not attempt to freeze fresh food inside the freezer compartment until this 24 hour time period has elapsed.
Once the 24 hour period has elapsed, you should set the temperature display to its normal operating temperature or switch off the
super frost setting.
Do not defrost the appliance with other electrical devices (e.g. hair dryers). Do not use sharp metal objects to
remove the ice on the freezer, as this could cause damage to the refrigeration system.
8
©
2017 Focal Point Fires plc.
7.0 REVERSING THE DOORS - CONTINUED
GB IE
8.0 CLEANING AND MAINTENANCE
9.0 INSTALLATION
IMPORTANT: Before installation and usage read all the instructions and make sure that the voltage (V) and the
frequency (Hz) indicated on the rating plate are exactly the same as the voltage and frequency in your home. The
rating plate can be found on the front left edge of the inside edge of the refrigerator.
The manufacturer declines all responsibility in the event of the installer failing to observe all the accidental prevention regulations in
force, which are necessary for use and the regular operation of the electric system.
Electrical Connections
THE FRIDGE/FREEZER IS INTENDED FOR FITTED AND PERMANENT INSTALLATION.
We recommend that the appliance is connected by a qualified electrician who is a member of the N I C E I C and who will comply
with the I.E.E. and local regulations.
Your refrigerator comes supplied with a 13 amp plug fitted. If in future you need to change the fuse in the plug then a 13 amp ASTA
approved (BS 1362) fuse must be fitted. WARNING: THIS APPLIANCE MUST BE EARTHED!
11. Refit the top hinge cover.
12. Correctly position the top door and then secure the top hinge.
13. Install the four screw caps and two catches to corresponding position.
Ensure the Appliance is unplugged and empty.
•
Adjust the two leveling feet to their highest position.
•
We recommend you have someone to assist you.
•
14. Replace the leveler to the other side and adjust it to make sure the cabinet is level.
