7
.0 OPERATING THE APPLIANCE - CONTINUED
8
GB IE
©
202
1
Focal Point Fires Ltd.
The remote control requires 2xAAA size batteries (Not included).
Open the battery compartment by sliding the cover down and insert the batteries noting the polarity indicated in the battery compartment.
Keep batteries out of reach of children.
Remote control operations are identical to the functions on the control panel.
The remote control must be point directly at the sensor on control pad.
2x AAA, 1.5V
Display
Standby mode icon
Timer icon
Timer OFF
Temperature/ timer number
Timer ON
Time/ temperature display
Automatic heating
Flame effect brightness
Heating level
Low heating level
High heating level
Day of the week
Settings
Setting weekday and time
Press the DAY/TIME key. When the day is flashing press the
▲
or
▼
key to select the day.
Press the DAY/TIME key again, then press the + or – key to set the hour.
Press the DAY/TIME key again, then press the + or – key to set the minute.
Press the OK key to confirm the setting.
Setting temperature
NOTE: This setting is only applicable for the temperature in standard heating mode, not for the temperature in the timer mode.
The default set temperature is 25
℃
.
NOTE: The heater only starts working when the set temperature is higher than the room temperature.
Press the + or – key to set the temperature, which ranges from 15 to 30
℃
.
After the temperature setting has been completed, the display flashes about 5 seconds, then shows the room temperature.
Setting timer
There can be up to 10 different timer settings that can be programmed.
Each timer setting has its day, power-on time and power-off time.
The maximum duration of each timer setting is 23 hours 50 minutes.
If the power-off time of the timer setting falls on the following day, it is unnecessary to set the day-just set the power-off time.
Press the TIMER SET key, the timer number starts blinking (01-10).
Press the + or – key to select a timer number.
