5
Operating instructions for DIESELFIxx / DIESELMAxx
G
Figure 3-1: Removal of cover
4 screws (not supplied) with diameter less than 9 mm are required to attach the fuelling station unit. Select
suitable screws according to the surface on which the unit is to be mounted..
Screw in the screws so far, that between screw head and wall approx. 5 mm of space remains.
Hang the housing onto the screws, then tighten screws through the openings in the rear panel.
Remove the plastic plugs from the suction and discharge junctions.
Connect hose to the suction connector. Attach a strainer to the end of the suction hose.
Connect the nozzle valve and swivel joint to the pressure hose and hang them in the pistol holder on the
front panel.
Caution!
Nozzle valve must be hung up, in order to prevent inadvertent starting of the pump when
■
■
connecting to the power supply.
Connect the pump to a 230 V supply through the power connector.
Lift the nozzle valve briefly from the holder to check if the pump starts up. Actuate the rocker switch on
the pump if the pump does not start. Return the fuel nozzle to the holder.
Screw the main assembly and cover together.
Refit the adaptor on the pressure side.
Connect filter and delivery hose to the delivery connector.
Mount the reset wheel for the meter.
Connect the drum adapter to the suction side.
The pump is now ready for operation.
Tip
Pay attention to cleanliness and the acurate connection of the accessories when assembling.
Use suitable sealing and adhesives (for example Teflon tape).
